xA L4-1.5L (1NZ-FE) (2006)
3. INSPECT AND ADJUST CLUTCH RELEASE POINT
a. Check the clutch release point.
1. Pull the parking brake lever and install wheel chocks.
2. Start the engine and run it at idle.
3. Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears contact.
4. Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full
stroke end position.
Standard distance: 25 mm (0.98 inch) or more
(From pedal stroke end position to release point)
If the distance is not as specified, perform these operations.
^ Check pedal height.
^ Check push rod play and pedal free play.
^ Bleed air from clutch line.
^ Check clutch cover and disc.