xA L4-1.5L (1NZ-FE) (2006)
c. Using a dial gauge, measure the disc runout.
Maximum runout: 0.8 mm (0.031 inch)
If the runout is greater than the maximum, replace the clutch disc assembly.
2. INSPECT CLUTCH COVER ASSEMBLY
a. Using a vernier caliper, measure the diaphragm spring for depth and width of wear.
Maximum wear
Maximum wear
If the wear is greater than the maximum, replace the clutch cover assembly.
3. INSPECT FLYWHEEL SUB-ASSEMBLY
a. Using a dial gauge, measure the flywheel runout.
Maximum deviation: 0.1 mm (0.004 inch)
If the runout is greater than the maximum, replace the flywheel sub-assembly.