xA L4-1.5L (1NZ-FE) (2006)
/Page-1492005.png)
5. INSTALL NO. 1 WINDSHIELD GLASS STOPPER
a. Install 2 new stoppers to the vehicle body as shown in the illustration.
6. INSTALL WINDSHIELD GLASS ADHESIVE DAM
a. Apply Primer G to the glass where the glass adhesive dams will be installed.
HINT: If primer G is applied to an area that is not specified, wipe off the primer with white gasoline before it dries.
NOTE:
-
Allow the primer to dry for 3 minutes or more.
-
Throw away any leftover primer.
-
Do not apply too much primer.
b. Remove the peeling paper from the adhesive part of the dam. Install the dam (adhesive side) to the glass (Primer G area), but exclude the
installation parts of the stopper (area c) as shown in the illustration.
7. INSTALL WINDSHIELD MOULDING OUTSIDE
