xB L4-1.5L (1NZ-FE) (2004)
Keyless Entry Transmitter Battery: Service and Repair
TRANSMITTER BATTERY
REPLACEMENT
1. REMOVE TRANSMITTER BATTERY
NOTE: Special caution should be taken for handling each component as they are precision electronic components.
a. Using a screwdriver, pry out the transmitter case.
NOTE: Do not forcibly pry out the case.
b. Remove the battery (lithium battery).
NOTE:
-
Do not push the terminals with your finger.
-
Prying up the battery (lithium battery) to forcibly remove it will cause deformation of the terminals.
-
Do not touch the battery with wet hands. Water may cause unexpected rust.
-
Do not touch or move any components inside the transmitter as it may interfere with proper operation.
2. INSTALL TRANSMITTER BATTERY
a. Install a new battery (lithium battery) with the positive (+) side up, as shown in the illustration.
NOTE:
-
Be sure that the positive side and the negative side of the transmitter battery are matched-up correctly.
-
Be careful not to bend the electrode of the transmitter battery insertion.
-
Be careful that dust or oil does not adhere to the transmitter case.