xB L4-2.4L (2AZ-FE) (2009)
(c) Install the brake pedal return spring.
6. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
(a) Install a new stop light switch mounting adjuster onto the pedal support.
7. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Insert the stop light switch into the adjuster until it just touches the brake pedal.
NOTICE: Do not depress the brake pedal.
(b) Make a quarter turn clockwise to install the stop light switch.
NOTICE: Do not depress the brake pedal.
HINT: The turning torque for installing the stop light switch:
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf) or less
(c) Check the stop light switch clearance.
Stop light switch clearance:
1.5 to 2.5 mm (0.059 to 0.098 in.)
(d) Engage the 2 harness clamps to the pedal support.
(e) Connect the connector to the stop light switch.
8. INSPECT AND ADJUST BRAKE PEDAL See: Adjustments
9. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Lower Instrument Panel/Installation
10. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Upper Instrument Panel/Installation
11. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Upper Instrument Panel/Installation