xB L4-2.4L (2AZ-FE) (2009)
8. REMOVE REAR DISC See: Disc Brake System/Service and Repair/Removal and Replacement/Rear Brake/Removal
9. DISCONNECT SPEED SENSOR WIRE
(a) Using a screwdriver, disengage the claw and disconnect the speed sensor wire connector.
NOTICE: Do not remove the connector cover from the connector because the speed sensor wire may be damaged.
10. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Removal
Installation
BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION
INSTALLATION
1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Installation
2. INSPECT REAR AXLE HUB BEARING LOOSENESS See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
3. INSPECT REAR AXLE HUB RUNOUT See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
4. CONNECT SPEED SENSOR WIRE
(a) Connect the speed sensor wire connector to the speed sensor.
5. INSTALL REAR DISC See: Disc Brake System/Service and Repair/Removal and Replacement/Rear Brake/Installation
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Installation
7. INSTALL PARKING BRAKE CABLE ASSEMBLY See: Disc Brake System/Service and Repair/Removal and Replacement/Rear
Brake/Installation
8. INSTALL REAR FLOOR SIDE MEMBER COVER See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Installation
9. ADJUST PARKING BRAKE LEVER TRAVEL See: Parking Brake System/Adjustments
10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Installation
11. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
13. INSPECT REAR WHEEL ALIGNMENT
See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment
14. CHECK VSC SENSOR SIGNAL
See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure