xB L4-2.4L (2AZ-FE) (2009)
(d) AIR CONDITIONING AMPLIFIER
HINT:
-
DTC communication uses the CAN communication system.
-
This DTC is output when the CAN communication system is malfunctioning and is not stored as a past DTC.
(e) ECM
GHINT: 8GDTC communication uses the CAN communication system.
(f) CENTER AIRBAG SENSOR ASSEMBLY
HINT:
-
The center airbag sensor assembly is connected to the CAN communication system but CAN communication DTCs are not output.
-
If "SRS Airbag" is not displayed on the "Communication Bus Check" screen on the Techstream, proceed to "Center Airbag Sensor
Communication Stop Mode." See: Component Tests and General Diagnostics/Center Airbag Sensor Communication Stop Mode
(g) MAIN BODY ECU
HINT:
-
The main body ECU is connected to the CAN communication system but CAN communication DTCs are not output.
-
If "Main Body" is not displayed on the "Communication Bus Check" screen on the Techstream, proceed to "Main Body ECU
Communication Stop Mode." See: Component Tests and General Diagnostics/Main Body ECU Communication Stop Mode
(h) BUS BUFFER ECU
HINT:
-
The bus buffer ECU is connected to the CAN communication system but CAN communication DTCs are not output.
-
If "Accessory Gateway" is not displayed on the "Communication Bus Check" screen on the Techstream, proceed to "Bus Buffer ECU
Communication Stop Mode." See: Component Tests and General Diagnostics/Bus Buffer ECU Communication Stop Mode
4. DTC COMBINATION TABLE