xB L4-2.4L (2AZ-FE) (2009)
/Page-818020.png)
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO DLC3 (CAN-H, CAN-L)
OK -- Continue to next step.
2. CONNECT CONNECTOR
(a) Reconnect the CAN center junction connector.
NEXT -- Continue to next step.
3. CHECK CAN BUS LINE FOR SHORT TO +B (CAN LH J/C SIDE)
(a) Turn the ignition switch off.
(b) Disconnect the A33 CAN LH junction connector connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance: