xB L4-2.4L (2AZ-FE) (2009)
/Page-1340003.png)
(a) Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.
(b) Install the 3 planetary gears into the motor terminal starter kit.
2. INSTALL STARTER ARMATURE ASSEMBLY
(a) Apply high-temperature grease to the plate washer and the armature shaft.
(b) Install the starter armature assembly into the starter commutator end frame assembly.
(c) Using snap ring pliers, install the plate washer and a new snap ring.
(d) Using vernier calipers, measure the snap ring.
Maximum length:
5.0 mm (0.197 in.)
If the length is greater than the maximum, replace the snap ring with a new one.
3. INSTALL STARTER COMMUTATOR END FRAME COVER
(a) Install the starter commutator end frame cover onto the starter commutator end frame assembly.
4. INSTALL STARTER ARMATURE PLATE
(a) Align the claw of the armature plate with the groove inside the starter yoke assembly, and install the starter armature plate.