xB L4-2.4L (2AZ-FE) (2009)
(a) Align the round hole in the No. 1 steering column hole cover sub-assembly with the protrusion of the steering link assembly to install the
cover.
6. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal
and Replacement/Engine Assembly/Installation
7. INSTALL FRONT SUSPENSION MEMBER REAR BRACE LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
8. INSTALL FRONT SUSPENSION MEMBER REAR BRACE RH
HINT: Perform the same procedure as for the LH side.
9. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH See: Suspension/Wheel Hub/Service and Repair/Front Axle
Hub/Installation
10. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
11. INSTALL TIE ROD END SUB-ASSEMBLY LH
(a) Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
NOTICE: Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
(b) Install a new cotter pin.
12. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
13. INSTALL FRONT STABILIZER LINK ASSEMBLY LH See: Suspension/Suspension Strut / Shock Absorber/Service and Repair/Front Shock
Absorber/Installation
14. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
15. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal
and Replacement/Engine Assembly/Installation
16. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
HINT: Perform the same procedure as for the LH side.
17. INSTALL REAR ENGINE UNDER COVER LH
18. INSTALL REAR ENGINE UNDER COVER RH
19. INSTALL NO. 2 ENGINE UNDER COVER
20. INSTALL NO. 1 ENGINE UNDER COVER