xB L4-2.4L (2AZ-FE) (2009)
Replacement/Removal
15. SEPARATE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY See: Steering/Steering Gear/Service and Repair/Removal
16. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
(a) Remove the nut and separate the stabilizer link assembly LH from the front stabilizer bar.
NOTICE: If the ball joint turns together with the nut, use a hexagon wrench (6mm) to hold the stud bolt.
17. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
18. SEPARATE TIE ROD END SUB-ASSEMBLY LH See: Steering/Steering Gear/Service and Repair/Removal
19. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
20. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH
(a) Remove the 4 bolts and front suspension member reinforcement LH.
21. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
(a) Remove the 4 bolts and front suspension member reinforcement RH.
22. REMOVE FRONT SUSPENSION MEMBER BRACE REAR LH
(a) Remove the 3 bolts and front suspension member brace rear LH.
23. REMOVE FRONT SUSPENSION MEMBER BRACE REAR RH
HINT: Perform the same procedure as for the LH side.
24. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY (for Manual Transaxle)