xB L4-2.4L (2AZ-FE) (2009)
(a) Slowly lower the jack, and remove the rear coil spring.
NOTICE:
-
When reusing the rear coil spring, make sure that the identification mark is at the position shown in the illustration.
-
If the identification mark has come off, apply new paint at the position shown in the illustration.
-
When moving the rear axle beam assembly beyond full rebound, make sure that the beam is not out of position for more than 10 minutes.
HINT: Check the identification mark on the RH side following the same procedures as the LH side.
11. REMOVE REAR COIL SPRING UPPER INSULATOR
12. REMOVE REAR COIL SPRING LOWER INSULATOR