xB L4-2.4L (2AZ-FE) (2009)
(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
SST: 09611-12010
9. INSTALL REAR AXLE HUB BOLT
(a) Install a washer and nut onto a new bolt as shown in the illustration.
(b) Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
10. INSTALL REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and Replacement/Rear
Brake/Installation
11. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
12. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY See: Suspension/Axle Beam/Service and Repair/Installation
13. INSPECT PARKING BRAKE LEVER TRAVEL See: Brakes and Traction Control/Parking Brake System/Adjustments
14. ADJUST PARKING BRAKE LEVER TRAVEL See: Brakes and Traction Control/Parking Brake System/Adjustments
15. INSTALL REAR FLOOR SIDE MEMBER COVER See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and
Repair/Installation
16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Installation
17. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)