xB L4-2.4L (2AZ-FE) (2009)
(f) Using a snap ring expander, install a new shaft snap ring.
(g) Pack the inboard joint shaft and boot with grease from the boot kit.
Standard grease capacity:
175 to 185 g (6.2 to 6.5 oz.)
(h) Align the matchmarks, and install the inboard joint onto the outboard joint shaft.
15. INSTALL FRONT DRIVE INBOARD JOINT ASSEMBLY RH
HINT: Use the same procedure as for the LH side.
16. INSTALL FRONT AXLE INBOARD JOINT BOOT
HINT: Use the same procedure for both sides.
(a) Install the inboard joint boot into the inboard joint and the groove on the outboard joint shaft.
NOTICE: Keep the groove where you are fitting the boot free of grease.
HINT: Install the inboard joint boot so that dimension (A) shown in the illustration is the same as the standard value.
Standard reference value:
17. INSTALL FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP LH
(a) Using a screwdriver, install the inboard joint boot clamp, as shown in the illustration (for One Touch Type).
NOTICE: Be careful not to damage the boot.
(b) Using needle-nose pliers, install the inboard joint boot clamp, as shown in the illustration (for Claw Engagement Type).
NOTICE: Be careful not to damage the boot.