xB L4-2.4L (2AZ-FE) (2009)
![background image](/scion/xb/l4-2.4l_(2az-fe)/Page-1151001.png)
Seals and Gaskets: Service and Repair
Replacement
E351 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT
REPLACEMENT
1. DRAIN TRANSAXLE OIL
(a) Remove the filler plug and gasket.
(b) Remove the drain plug and gasket, and then drain the manual transaxle oil.
(c) Install a new gasket and the drain plug.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
2. REMOVE FRONT WHEELS
3. REMOVE FRONT AXLE HUB NUT LH See: Drive Axles, Bearings and Joints/Wheel Hub/Service and Repair/Front Axle Hub/Removal
4. REMOVE FRONT AXLE HUB NUT RH
HINT: Perform the same procedure as for the LH side.
5. REMOVE FRONT SPEED SENSOR LH See: Drive Axles, Bearings and Joints/Wheel Hub/Service and Repair/Front Axle Hub/Removal
6. REMOVE FRONT SPEED SENSOR RH
HINT: Perform the same procedure as for the LH side.
7. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH See: Drive Axles, Bearings and Joints/Wheel Hub/Service and
Repair/Front Axle Hub/Removal
8. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
9. SEPARATE TIE ROD END SUB-ASSEMBLY LH See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Removal
10. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Front Shock Absorber/Removal
12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
13. SEPARATE FRONT AXLE ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Removal
14. SEPARATE FRONT AXLE ASSEMBLY RH
HINT: Perform the same procedure as for the LH side.
15. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
and Replacement/Removal
16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal
and Replacement/Removal
17. REMOVE TRANSAXLE CASE OIL SEAL LH
(a) Using SST, tap out the transaxle case oil seal.
SST: 09308-00010