xB L4-2.4L (2AZ-FE) (2009)
(b) Remove the windshield outside moulding.
HINT:
Make a partial cut in the windshield outside moulding. Then pull and remove it by hand.
25. REMOVE WINDSHIELD GLASS
(a) Disconnect the stoppers.
NOTICE:
-
There are No. 1 and No. 2 stoppers on the windshield glass as shown in the illustration. Be careful not to damage the windshield glass
when cutting off the adhesive.
-
To prevent the windshield glass from dropping when performing this operation, be sure to hold the windshield glass using suction cups.
HINT:
Depending on vehicles, a 1-piece or 2-piece type stopper is used.
(b) Apply protective tape to the installation area on the windshield glass on the vehicle body.
HINT:
Apply protective tape to the installation surface to prevent it from being scratched.