xD L4-1.8L (2ZR-FE) (2008)
BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR CONSOLE BOX COVER See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
3. REMOVE YAW RATE AND ACCELERATION SENSOR PROTECTOR
(a) Remove the 2 nuts and yaw rate and acceleration sensor protector.
4. REMOVE YAW RATE AND ACCELERATION SENSOR
(a) Disconnect the yaw rate and acceleration sensor connector.
(b) Remove the 2 bolts and yaw rate and acceleration sensor.
Installation
BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL YAW RATE AND ACCELERATION SENSOR
(a) Install the yaw rate and acceleration sensor with the 2 bolts.
Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)
(b) Connect the yaw rate and acceleration sensor connector.
2. INSTALL YAW RATE AND ACCELERATION SENSOR PROTECTOR