xD L4-1.8L (2ZR-FE) (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Removal
BRAKE CONTROL: BRAKE ACTUATOR: REMOVAL
REMOVAL
1. DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.
2. REMOVE COWL TOP VENTILATOR LOUVER CENTER See: Brake Bleeding/Service and Repair/Replacement
3. REMOVE BATTERY
4. REMOVE BATTERY TRAY
5. REMOVE BATTERY CARRIER
6. REMOVE BRAKE ACTUATOR ASSEMBLY (w/o VSC)
(a) Release the lock lever and disconnect the brake actuator connector.
NOTE: Be careful not to allow brake fluid to enter the removed connector.
(b) Using a union nut wrench, separate the 6 brake tubes from the brake actuator.
(c) Use tags or labels to identify the place to reconnect each brake tube.
HINT:
-
*1: To front wheel cylinder RH
-
*2: To front wheel cylinder LH
-
*3: To rear wheel cylinder RH
-
*4: To rear wheel cylinder LH
-
*5: From 1st master cylinder
-
*6: From 2nd master cylinder