xD L4-1.8L (2ZR-FE) (2008)
BRAKE CONTROL: REAR SPEED SENSOR: REMOVAL
REMOVAL
1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY See: Drum Brake System/Service and Repair/Removal
3. DISCONNECT SPEED SENSOR WIRE See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle Hub/Removal
4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Removal
5. REMOVE REAR SPEED SENSOR
(a) Mount the rear axle hub and bearing assembly in a vice between aluminum plates.
NOTE: If it is dropped or heavily damaged, replace the rear axle hub and bearing assembly.
(b) Using a pin punch and hammer, remove the 2 pins from SST (09520-00031) and remove the attachment (09521-00010).
(c) Using SST and the 2 bolts (90101-12007), remove the speed sensor from the rear axle hub.
SST: 09520-00031
09520-00040
SST: 09521-00020
SST: 09950-00020
NOTICE:
-
Pull the speed sensor off straight, being careful not to make contact with the speed sensor rotor.
-
If the speed sensor rotor is damaged or deformed, replace the rear axle hub and bearing assembly.
-
Do not damage the speed sensor or rear axle hub contact surfaces.
-
Keep the sensor rotor free of foreign matter.
Installation
BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION
INSTALLATION
1. INSTALL REAR SPEED SENSOR
(a) Wipe the sealant off the speed sensor installation surface using non-residue solvent.
NOTE: Keep the sensor rotor free of foreign matter.