xD L4-1.8L (2ZR-FE) (2008)
BRAKE: REAR BRAKE FLEXIBLE HOSE: REMOVAL
REMOVAL
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.
3. REMOVE REAR BRAKE FLEXIBLE HOSE
(a) Using a union nut wrench, separate the brake tubes while holding the flexible hose with a wrench.
NOTICE:
-
Do not bend or damage the brake tube.
-
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting position.
(b) Remove the 2 clips and flexible hose from the axle beam.
Installation
BRAKE: REAR BRAKE FLEXIBLE HOSE: INSTALLATION
INSTALLATION
1. INSTALL REAR BRAKE FLEXIBLE HOSE
(a) Install the flexible hose with 2 new clips onto the axle beam.
(b) Using a union nut wrench, install the 2 brake tubes onto the flexible hose while holding the flexible hose with a wrench.
without union nut wrench - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with union nut wrench - Torque: 14 Nm (144 kgf-cm, 10 ft-lbf)
NOTICE:
-
This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a