xD L4-1.8L (2ZR-FE) (2008)
(c) Using a union nut wrench, install the 2 brake tubes onto the brake master cylinder sub-assembly.
without union nut wrench - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with union nut wrench - Torque: 14 Nm (144 kgf-cm, 10 ft-lbf)
NOTICE:
-
This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a
fulcrum length of 22 mm (0.866 in.) .
-
This torque value is effective when the union nut wrench is parallel to a torque wrench.
(d) Connect the brake fluid level warning switch connector.
3. CONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle)
(a) Connect the clutch reservoir tube with the clip.
4. INSTALL BATTERY CARRIER
5. INSTALL BATTERY TRAY
6. INSTALL BATTERY
7. FILL RESERVOIR WITH BRAKE FLUID See: Brake Bleeding/Service and Repair/Replacement
8. BLEED MASTER CYLINDER See: Brake Bleeding/Service and Repair/Replacement
9. BLEED BRAKE LINE See: Brake Bleeding/Service and Repair/Replacement
10. BLEED BRAKE ACTUATOR (w/ VSC) See: Brake Bleeding/Service and Repair/Replacement
11. CHECK FLUID LEVEL IN RESERVOIR See: Brake Bleeding/Service and Repair/Replacement