xD L4-1.8L (2ZR-FE) (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Installation
BRAKE CONTROL: BRAKE ACTUATOR: INSTALLATION
INSTALLATION
1. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY (w/o VSC)
(a) Install the actuator bracket with the 3 bolts in the sequence shown in the illustration.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTE:
-
Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
-
Do not carry with the connector part of an actuator.
2. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY (w/ VSC)
(a) Install the actuator bracket with the 4 bolts in the sequence shown in the illustration.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTE:
-
Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
-
Do not carry with the connector part of an actuator.
3. INSTALL BRAKE ACTUATOR ASSEMBLY (w/o VSC)
(a) Install the brake actuator with bracket with the 3 bolts in the sequence shown in the illustration.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
NOTE: Do not damage the brake tubes or wire harness.