xD L4-1.8L (2ZR-FE) (2008)
Parking Brake Cable: Service and Repair
Installation
PARKING BRAKE: PARKING BRAKE CABLE: INSTALLATION
INSTALLATION
1. INSTALL PARKING BRAKE CABLE ASSEMBLY
(a) Install the parking brake cable onto the backing plate with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Install cable clamp B onto the rear axle beam.
NOTE: Securely install the clamp.
HINT: When reusing the parking brake cable assembly, replace cable clamp B with a new part.
(c) Tighten the 4 bolts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(d) Pass the parking brake cable through a new cable clamp A, and then install cable clamp A onto the stud bolt.
NOTE: Securely install the clamp.