xD L4-1.8L (2ZR-FE) (2008)
BRAKE CONTROL: FRONT SPEED SENSOR: REMOVAL
REMOVAL
1. REMOVE FRONT WHEEL
2. REMOVE ROCKER PANEL MOULDING COVER See: Body and Frame/Spoilers, Flaps, and Air Dams/Mud Flap/Service and Repair/Removal
3. REMOVE SIDE MUDGUARD See: Body and Frame/Spoilers, Flaps, and Air Dams/Mud Flap/Service and Repair/Removal
4. REMOVE FRONT FENDER LINER See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service and
Repair/Removal
5. REMOVE FRONT SPEED SENSOR
(a) Disengage the clamp A from the body.
(b) Disconnect the speed sensor connector.
(c) Disengage the clamps B, C and D from the body.
(d) Remove the bolt and separate the No. 2 sensor clamp from the body.
(e) Remove the bolt and separate the No. 1 sensor clamp from the shock absorber.
(f) Remove the bolt and remove the speed sensor from the steering knuckle.
NOTICE:
-
Keep the speed sensor tip and installation portion free of foreign matter.
-
Remove the speed sensor without turning it from its original installation angle.
Installation
BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION
INSTALLATION
1. INSTALL FRONT SPEED SENSOR