xD L4-1.8L (2ZR-FE) (2008)
Water Pump: Service and Repair
Installation
2ZR-FE COOLING: WATER PUMP: INSTALLATION
INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
(a) Install a new water pump gasket to the timing chain cover.
HINT: Make sure that the installation surfaces are clean.
(b) Install the water pump assembly with the 5 bolts.
Torque: 26 Nm (260 kgf-cm, 19 ft-lbf)
Torque: 24 Nm (240 kgf-cm, 17 ft-lbf)
2. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine
Assembly/Installation
3. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
4. INSTALL FRONT AXLE ASSEMBLY LH See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Installation
5. INSTALL FRONT AXLE ASSEMBLY RH
HINT: The installation procedure for the RH side is the same as that for the LH side.
6. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair/Installation
7. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT: The installation procedure for the RH side is the same as that for the LH side.
8. INSTALL FRONT STABILIZER LINK ASSEMBLY LH See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation