xD L4-1.8L (2ZR-FE) (2008)
Alignment: Service and Repair
Front Wheel Alignment
SUSPENSION: FRONT WHEEL ALIGNMENT: ADJUSTMENT
ADJUSTMENT
NOTE: For vehicles equipped with VSC, if the wheel alignment has been adjusted, and if suspension or underbody components have been
removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:
1. Disconnect the negative battery terminal for more than 2 seconds.
2. Reconnect the negative battery terminal.
3. Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection. See: Brakes and Traction Control/Antilock Brakes
/ Traction Control Systems/Testing and Inspection/Component Tests and General Diagnostics/Vehicle Stability Control System/Calibration
1. INSPECT TIRES See: Wheels and Tires/Testing and Inspection/Component Tests and General Diagnostics
2. MEASURE VEHICLE HEIGHT
Vehicle height (unloaded vehicle):
Measuring points:
A
Ground clearance of front wheel center
B
Ground clearance of front lower arm set front bolt center
C
Ground clearance of rear wheel center
D
Ground clearance of axle beam set bolt center
NOTE: Before inspecting the wheel alignment, check the vehicle height.
HINT: Bounce the vehicle up and down at the corners to stabilize the suspension before inspecting the vehicle height.