xD L4-1.8L (2ZR-FE) (2008)
Drive Belt: Service and Repair
Installation
2ZR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION
INSTALLATION
1. INSTALL FAN AND GENERATOR V BELT
(a) Provisionally install the fan and generator V belt onto each pulley.
NOTE: Make sure that the V belt is securely fitted into the rib groove of the pulley.
2. ADJUST FAN AND GENERATOR V BELT
(a) Turn adjusting bolt C and adjust the tension of the V belt.
NOTE: Check that bolt D is tightened to the specified torque of 19 N*m (189 kgf*cm, 14 ft.*lbf).
(b) Tighten fixing bolts A and B.
Torque: 19 Nm (189 kgf-cm, 14 ft-lbf) for bolt A
Torque: 43 Nm (438 kgf-cm, 32 ft-lbf) for bolt B
3. INSPECT FAN AND GENERATOR V BELT
(a) Check the V belt deflection and tension.
Deflection:
Tension: