scion Workshop Repair Guides

Scion Workshop Service and Repair Manuals

Engine Controls - MIL/Hard Start/DTC's P0300-304/P0015|Page 2801 > < Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 2796
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Engine Controls - MIL/Hard Start/DTC's P0300-304/P0015

S-SB-0032-09

June 19, 2009

No Start or Extended Crank and/or MIL "ON" DTC P030 # or P0015

Service Category

Engine/Hybrid System

Section
Engine Control

Market
USA

Applicability

Introduction

Some 2008 - 2009 model year Scion xD vehicles may exhibit one or more of the following conditions after a cold soak due to carbon accumulation in
the engine combustion chambers:

^

Crank No Start

^

Extended Crank

^

MIL "ON" DTC P0300, P0301 P0302, P0303, P0304, and/or P0015 set within 60 seconds of engine run time.

The Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) logic has been modified to improve this condition. Use the following
repair procedure to address customer concerns.

Warranty Information

APPLICABLE WARRANTY

^ This repair is covered under the Toyota Federal Emission Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first,

from the vehicle's in-service date.

^ Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Parts Information

NOTE

Engine Controls - MIL/Hard Start/DTC's P0300-304/P0015|Page 2801 > < Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 2796