xD L4-1.8L (2ZR-FE) (2008)
(a) Disconnect the F38 main body ECU connector.
(b) Select "CAN Bus Check" on the Techstream See: Initial Inspection and Diagnostic Overview/Diagnosis System.
Result:
B -- CHECK OPEN IN ONE SIDE OF CAN BRANCH WIRE (YAW RATE SENSOR)
A -- Continue to next step.
12. CHECK OPEN IN ONE SIDE OF CAN BRANCH WIRE (MAIN BODY ECU BRANCH WIRE)
(a) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F38 main body ECU connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO MAIN BODY ECU (CAN-H, CAN-L)
OK -- REPLACE MAIN BODY ECU
13. CHECK OPEN IN ONE SIDE OF CAN BRANCH WIRE (YAW RATE SENSOR)
NOTE: For vehicles without VSC, go to step 15.