xD L4-1.8L (2ZR-FE) (2008)
1. CHECK CAN BUS LINE CONNECTION (ABS AND TRACTION ACTUATOR (SKID CONTROL ECU) BRANCH WIRE)
(a) Turn the ignition switch off.
(b) Disconnect the A15 ABS and traction actuator (skid control ECU) connector.
(c) Measure the resistance according to the value in the table below.
Standard resistance:
(d) Reconnect the ABS and traction actuator (skid control ECU) connector.
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO ABS AND TRACTION ACTUATOR (SKID
CONTROL ECU) (CAN-H, CAN-L)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (IG1, GND1, GND2)
(a) Disconnect the A15 ABS and traction actuator (skid control ECU) connector.
(b) Measure the resistance according to the value in the table below.
Standard resistance:
(c) Measure the voltage according to the value in the table below.
Standard voltage:
(d) Reconnect the ABS and traction actuator (skid control ECU) connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE ABS AND TRACTION ACTUATOR (SKID CONTROL ECU)