xD L4-1.8L (2ZR-FE) (2008)
(a) Disconnect the F30 power steering ECU connector.
(b) Measure the resistance according to the values in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN MAIN WIRE CONNECTED TO POWER STEERING ECU (CAN-H, CAN-L)
OK -- REPLACE POWER STEERING ECU
16. CHECK CAN BUS LINE FOR SHORT TO +B (YAW RATE SENSOR BRANCH WIRE)
(a) Disconnect the F34 yaw rate sensor connector.