xD L4-1.8L (2ZR-FE) (2008)
(b) Measure the resistance according to the values in the table below.
HINT: The resistance must be measured after the F46 D-CAN junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO ABS AND TRACTION ACTUATOR (SKID
CONTROL ECU) (CAN-H, CAN-L)
OK -- REPLACE ABS AND TRACTION ACTUATOR (SKID CONTROL ECU)
21. CHECK CAN BUS LINE FOR SHORT TO GND (STEERING SENSOR BRANCH WIRE)
(a) Disconnect the F33 steering sensor connector.