xD L4-1.8L (2ZR-FE) (2008)
(a) Disconnect the F2 combination meter ECU connector.
(b) Measure the resistance according to the value in the table below.
HINT: The resistance must be measured after the F47 P-CAN junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO COMBINATION METER ECU (CAN-H, CAN-L)
OK -- REPLACE COMBINATION METER ECU
19. CHECK CAN BUS LINES FOR SHORT CIRCUIT (ECM MAIN WIRE)
(a) Disconnect the A21 ECM connector.