xD L4-1.8L (2ZR-FE) (2008)
(a) Turn the ignition switch off.
(b) Disconnect the F2 combination meter ECU connector.
(c) Measure the resistance according to the value in the table below.
Standard resistance:
(d) Reconnect the combination meter ECU connector.
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO COMBINATION METER ECU (CAN-H, CAN-L)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (IG2, ECUB, ET)
(a) Disconnect the F1 combination meter ECU connector.
(b) Measure the resistance according to the value table below.
Standard resistance:
(c) Measure the voltage according to the value in the table below.
Standard voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY
ECM Communication Stop Mode
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: ECM Communication Stop Mode