xD L4-1.8L (2ZR-FE) (2008)
(d) Reconnect the power steering ECU connector.
NG -- REPAIR OR REPLACE CAN MAIN WIRE CONNECTED TO POWER STEERING ECU (CAN-H, CAN-L)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (IG, PGND)
(a) Disconnect the F30 and A19 power steering ECU connector.
(b) Measure the resistance according to the value in the table below.
Standard resistance:
(c) Measure the voltage according to the value in the table below.
Standard resistance:
(d) Reconnect the power steering ECU connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE POWER STEERING ECU
Steering Angle Sensor Communication Stop Mode
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Steering Angle Sensor Communication Stop Mode
Steering Angle Sensor Communication Stop Mode
DESCRIPTION
HINT: For vehicle with VSC only.