xD L4-1.8L (2ZR-FE) (2008)
(d) Reconnect the steering sensor connector.
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO STEERING SENSOR (CAN-H, CAN-L)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (IG, ESS)
(a) Disconnect the F33 steering sensor connector.
(b) Measure the resistance according to the value in the table below.
Standard resistance:
(c) Measure the voltage according to the value in the table below.
Standard voltage:
(d) Reconnect the steering sensor connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE STEERING SENSOR
Yaw Rate Sensor Communication Stop Mode
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Yaw Rate Sensor Communication Stop Mode
Yaw Rate Sensor Communication Stop Mode
DESCRIPTION
HINT: For vehicles with VSC only.
WIRING DIAGRAM