xD L4-1.8L (2ZR-FE) (2008)
Knock Sensor: Service and Repair
Installation
2ZR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION
INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the knock sensor with the bolt as shown in the illustration.
Torque: 21 Nm (214 kgf-cm, 16 ft-lbf)
(b) Connect the knock sensor connector.
2. INSTALL INTAKE MANIFOLD
(a) Install a new gasket onto the intake manifold.
(b) Install the intake manifold and intake manifold stay with the 4 bolts and 2 nuts.
Torque: 28 Nm (286 kgf-cm, 21 ft-lbf)
(c) Connect the water by-pass hose and the No. 2 water by-pass hose.