xD L4-1.8L (2ZR-FE) (2008)
(d) Reconnect the ECM connector.
(e) Reconnect the combination meter connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY
5. CHECK THAT MIL IS ILLUMINATED
(a) Check if the MIL is illuminated when the ignition switch is turned to ON.
OK:
MIL should be illuminated.
NG -- CHECK THAT ENGINE STARTS
OK -- CHECK FOR INTERMITTENT PROBLEMS
6. CHECK THAT ENGINE STARTS
(a) Turn the ignition switch to ON.
(b) Start the engine.
Result:
HINT: *: A Techstream cannot communicate with the ECM.
B -- GO TO VC OUTPUT CIRCUIT
A -- Continue to next step.
7. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
(a) Disconnect the ECM connector.
(b) Disconnect the combination meter connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
(d) Reconnect the ECM connector.
(e) Reconnect the combination meter connector.