xD L4-1.8L (2ZR-FE) (2008)
5. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
6. REMOVE FRONT CONSOLE BOX
7. REMOVE HEATED OXYGEN SENSOR
(a) Disconnect the heated oxygen sensor connector.
(b) Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
(c) Remove the wire harness clamp bracket.
(d) Using SST, remove heated oxygen sensor.
SST: 09224-00010
Installation
2ZR-FE ENGINE CONTROL SYSTEM: HEATED OXYGEN SENSOR: INSTALLATION
INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR
(a) Using SST, install the heated oxygen sensor onto the front exhaust pipe.
SST: 09224-00010
without SST - Torque: 44 Nm (449 kgf-cm, 33 ft-lbf)
with SST - Torque: 40 Nm (408 kgf-cm, 30 ft-lbf)