xD L4-1.8L (2ZR-FE) (2008)
(g) Connect SST.
SST: 09082-00700
NOTE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock. Also, secure some slack for
the SST wire harness inside the tire.
(h) Deploy the airbag.
(1) Connect the red clip of SST to the positive battery terminal and the black clip of SST to the negative battery terminal.
(2) Check that no one is within a 10 m (33 ft) radius of the tire to which the curtain shield airbag is tied.
(3) Press the SST activation switch and deploy the airbag.
CAUTION: Make sure that no one is near the tire when deploying the airbag.
HINT: The airbag is deployed as the LED on the SST activation switch illuminates.
(i) Dispose of the curtain shield airbag.
CAUTION:
-
The curtain shield airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
-
Use gloves and safety glasses when handling a curtain shield airbag which has been deployed.
-
Always wash your hands with water after completing the operation.
-
Do not apply water, etc. to a curtain shield airbag which has been deployed.
(1) Remove the curtain shield airbag from the tire.
(2) Place the curtain shield airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.
Removal
SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
2. REMOVE DECK BOARD ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE NO. 1 REAR SEAT LEG COVER RH See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for RH Side)/Removal
4. REMOVE NO. 1 REAR SEAT LEG COVER LH See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for LH Side)/Removal
5. REMOVE NO. 2 REAR SEAT LEG COVER LH See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for LH Side)/Removal