xD L4-1.8L (2ZR-FE) (2008)
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL
REMOVAL
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag
system before servicing See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) See: Body and Frame/Interior Moulding / Trim/Console/Service
and Repair/Removal
3. REMOVE UPPER CONSOLE PANEL See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
4. REMOVE REAR CONSOLE BOX COVER See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
5. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
6. REMOVE FRONT CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Lower
Instrument Panel/Removal
7. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the
airbag sensor will cause the airbag to deploy.
(a) Pull the lever down and detach the connector holder.
(b) Remove the 3 bolts and remove the airbag sensor.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag
system before servicing See: Service Precautions.