xD L4-1.8L (2ZR-FE) (2008)
/Page-1853007.png)
-
Set up the front seat outer belt, as shown in the illustration.
(4) Move SST at least 10 m (33 ft) away from the wheel.
NOTE: Take care not to damage the SST wire harness.
(f) Activate the seat belt pretensioner.
(1) Connect the SST red clip to the positive battery terminal and the black clip to the negative battery terminal.
(2) Check that no one is within 10 m (33 ft) of the wheel.
(3) Press the SST activation switch and activate the seat belt pretensioner.
HINT: The seat belt pretensioner operates simultaneously with the SST activation switch LED light.
(g) Disconnect SST.
(h) Dispose of the front seat outer belt (with the seat belt pretensioner).
CAUTION:
-
Do not touch the front seat outer belt for at least 30 minutes after the seat belt pretensioner has been activated. It is very hot.
-
Use gloves and safety glasses when handling a front seat outer belt with a pretensioner that has been activated.
-
Always wash your hands with water after completing the operation.
-
Do not apply water to a front seat outer belt that has an activated pretensioner.
(1) Place the front seat outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.
Removal
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL
REMOVAL
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag
system before servicing See: Air Bag Systems/Service Precautions.
HINT: The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
2. REMOVE FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
