xD L4-1.8L (2ZR-FE) (2008)
/Page-1854004.png)
NOTE: Always use "TORX" socket wrench E10 when installing the front seat.
HINT: The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless
otherwise specified.
1. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
(a) Install the front seat inner belt with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE: Do not place the front seat inner belt over the convex areas of the front seat frame adjuster.
(b) Install the wiring harness into the claw on the front seat cushion shield.
(c) Install the 2 wiring harness clamps.
(d) Install the buckle switch connector.
(e) Connect the seat position sensor connector.
2. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
(a) Install the front seat inner belt with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE: Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.
(b) Install the wiring harness into the claw on the front seat cushion shield.
(c) Install the 2 wiring harness clamps.
(d) Install the buckle switch connector.
3. INSTALL FRONT SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Front Seat Assembly/Installation
