xD L4-1.8L (2ZR-FE) (2008)
SEAT BELT: REAR CENTER SEAT INNER BELT ASSEMBLY (for LH Side): REMOVAL
REMOVAL
NOTE: Always use "TORX" socket wrench E10 when removing the rear seat.
1. REMOVE NO. 1 REAR SEAT LEG COVER See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for LH Side)/Removal
2. REMOVE NO. 2 REAR SEAT LEG COVER See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for LH Side)/Removal
3. REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY
(a) Using "TORX" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.
(b) Remove the belt from the band.
(c) Remove the bolt and the rear center seat inner belt.
Installation
SEAT BELT: REAR CENTER SEAT INNER BELT ASSEMBLY (for LH Side): INSTALLATION
INSTALLATION
NOTE: Always use "TORX" socket wrench E10 when installing the rear seat.
1. INSTALL REAR CENTER SEAT INNER BELT ASSEMBLY
(a) Install the rear center seat inner belt with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE: Do not place the anchor plate over the convex areas of the rear seat back frame.
(b) Install the belt into the band.