xD L4-1.8L (2ZR-FE) (2008)
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: REMOVAL
REMOVAL
CAUTION: Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS
airbag system before servicing See: Air Bag Systems/Service Precautions.
HINT: The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE REAR DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
6. REMOVE CENTER PILLAR LOWER GARNISH RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
7. REMOVE SIDE AIRBAG SENSOR
CAUTION: Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the
airbag sensor will cause the airbag to deploy.
(a) Slide the outer housing and detach the airbag connector.
(b) Remove the bolt, disengage the hook and remove the side airbag sensor.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: INSTALLATION
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag
system before servicing See: Air Bag Systems/Service Precautions.
HINT: The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.