xD L4-1.8L (2ZR-FE) (2008)
Steering Angle Sensor: Service and Repair
Installation
BRAKE CONTROL: STEERING ANGLE SENSOR: INSTALLATION
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag
system before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
1. INSTALL STEERING ANGLE SENSOR
(a) Engage the 6 claws and insert the 2 pins into the holes to install the steering angle sensor onto the spiral cable.
2. INSTALL SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
3. INSTALL STEERING COLUMN UPPER COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Installation
4. INSTALL STEERING COLUMN LOWER COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Installation
5. ADJUST SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
6. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and Repair/Installation
7. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
8. TURN FRONT WHEELS FACING STRAIGHT AHEAD
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
10. INSPECT SRS WARNING LIGHT See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System