xD L4-1.8L (2ZR-FE) (2008)
(b) Install the speed sensor onto the rear axle hub in the highest possible installation position.
HINT: The distance between the installation holes should be larger on the upper side than the lower side.
(c) Using SST and a press, install a new speed sensor into the rear axle hub until it is flush with the end surface of the axle hub.
SST: 09214-76011
NOTICE:
-
Do not use a hammer when installing.
-
Make sure that the sensor probe is free of foreign matter.
-
Press the speed sensor in slowly without turning it.
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Installation
3. INSPECT REAR AXLE HUB BEARING See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
4. CONNECT SPEED SENSOR WIRE See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle Hub/Installation
5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
6. ADJUST REAR DRUM BRAKE SHOE CLEARANCE See: Brakes and Traction Control/Drum Brake System/Service and Repair/Installation
7. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
8. INSPECT REAR WHEEL ALIGNMENT See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment
9. CHECK ABS SENSOR SIGNAL (w/o VSC) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/ABS (Antilock Brake System)/Test Mode Procedure
10. CHECK VSC SENSOR SIGNAL (w/ VSC) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Vehicle Stability Control System/Test Mode Procedure