xD L4-1.8L (2ZR-FE) (2008)
Impact Sensor: Testing and Inspection
Rear Airbag Sensor
SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. INSPECT REAR AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes/DTC Check / Clear.
2. INSPECT REAR AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
CAUTION: For rear airbag sensor removal and installation procedures, See: Service and Repair/Rear Airbag Sensor/Removal and
See: Service and Repair/Rear Airbag Sensor/Installation, and carefully follow the correct procedure.
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes/DTC Check / Clear.
(b) When the center pillar of the vehicle or its periphery is damaged, check whether there is any damage to the rear airbag sensor. If there are any
defects, such as those mentioned below, replace the rear airbag sensor with a new one:
-
Any cracks, dents or chips in the case.
-
Any cracks or other damage to the connector.
-
Peeling of the label or damage to the serial number.
3. INSPECT REAR AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision)
CAUTION: For rear airbag sensor removal and installation procedures, See: Service and Repair/Rear Airbag Sensor/Removal and
See: Service and Repair/Rear Airbag Sensor/Installation, and carefully follow the correct procedure.
(a) Replace the rear airbag sensor.