xD L4-1.8L (2ZR-FE) (2008)
Starter Motor: Testing and Inspection
Starter
2ZR-FE STARTING: STARTER: INSPECTION
INSPECTION
1. INSPECT STARTER ASSEMBLY
NOTE: The following tests must be performed for no longer then 5 seconds to prevent the coil from burning out.
(a) Perform the pull-in test.
(1) Remove the nut and disconnect the lead wire from terminal C.
(2) Connect the battery to the starter magnetic switch as shown in the illustration. Check that the clutch pinion gear moves outward.
If the result is not as specified, replace the magnet starter switch assembly.
(b) Perform the holding test.
(1) Disconnect the negative (-) lead from terminal C. Check that the pinion gear remains out.
If the result is not as specified, replace the magnet starter switch assembly.
(c) Check the operation.
(1) Disconnect the negative (-) lead from the switch body. Check that the clutch pinion gear returns in ward.
If the result is not as specified, replace the magnet starter switch assembly.
(d) Perform the no-load performance test.
(1) Connect the lead wire to terminal C with the nut. Make sure that the lead is not grounded.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(2) Clamp the starter in a vise.