xD L4-1.8L (2ZR-FE) (2008)
/Page-1435004.png)
(b) Inspect the starter clutch.
(1) Rotate the clutch pinion gear clockwise and check that it turns freely. Try to rotate the clutch pinion gear counterclockwise and check that
it locks.
If necessary, replace the starter center bearing clutch sub-assembly.
5. INSPECT MAGNET SWITCH BODY
(a) Inspect the plunger.
(1) Push in the plunger and check that it returns quickly to its original position.
If necessary, replace the magnet switch body.
(b) Inspect the pull-in coil for open circuits.
(1) Measure the resistance according to the value (s) in the table below.
Standard resistance:
If the result is not as specified, replace the magnet switch body.
(c) Check whether the holding coil has an open circuit.
(1) Measure the resistance according to the value (s) in the table below.
Standard resistance:
